# Enable-Discovery-module-on-UCMDB-UI-on-SaaS_688987735
## Introduction

By default, on SaaS, users could only run discovery/integration on UCMDB Web UI.

In order to enable discovery module on Applet UI, you could invoke the JMX method **setSettingValue** with the parameter **appilog.collectors.enableZoneBasedDiscovery** and set it to **false**.

![](attachments/688987735/688987734.png)

Then in UCMDB UI, the following modules will be displayed (If you already opened Local Client, please close the old window, and open a new window):

\-Integration Studio

\-Universal Discovery

\-Service Discovery

\-Discovery job in Reconciliation Priority

\-Data Flow Probe Setup

\-Data Flow Probe Status

**Note the following if you decide to switch from UCMDB Web UI-based discovery solution to UCMDB UI-based discovery solution:**

- You CANNOT run discovery from both UCMDB Web UI and UCMDB UI at the same time. You can use either the UCMDB Web UI-based discovery solution, or the UCMDB UI-based discovery solution.
- DO NOT switch to UCMDB UI-based discovery solution if you already started using UCMDB Web UI for discovery. Otherwise the configuraitons you made in UCMDB Web UI will get lost.
- This setting takes effect immediately, no reboot required.
- This setting is controlled by the SaaS Ops team.
- After disabling this setting, users cannot run discovery/integration on UCMDB Web UI.

## Attachments:

[image2024-8-5\_15-21-7.png](attachments/688987735/688987734.png) (image/png)